Kee Klamp Galvanized Fittings

This fitting, with holes provided for countersunk flat head screw fixings only, is designed to carry handrails along walls or to fix structures back to walls. The pipe passes through the fitting and cannot be joined within the fitting. Type 70 is also used to attach toeboards to the base of guardrail uprights. Ø indicates diameter of fixing holes. These fittings are not to be used as base flanges for full height guardrails.

Type 71 is a weather cap designed for roof guardrailing to ensure a weathertight seal for base fixing flanges. The weather cap is secured to the upright by means of a combined sealant and adhesive.

Side fixing for guardrailing and balustrading to walls, parapets, steps and ramps. The upright cannot drop through the socket. Ø indicates diameter of fixing holes. If the upright is required to pass through the fitting by machining out the base stop, the bottom fixing hole will be unusable.

The Type 69 fitting has been designed for guardrailing and balustrading applications and provides the added benefit of attaching a toeboard to the base. The base plate holes are of sufficient diameter to allow for attachment with either a mechanical or chemical anchor, the side plates have slotted holes to allow for a degree of sideways movement for ease of installation. A toeplate designed for use with the Type 69 fitting is available from Kee Industrial Products. Ø indicates diameter of fixing holes.

A collar commonly used to support another fitting if the latter is required to be left untightened, such as on gate hinges. Type 75 is also useful when the loading on a structure exceeds the maximum permitted slip load for a set screw, as it gives extra support.

Single clips for attaching wire-mesh infilling. For economy it is possible to use Type 81 clips without the safety attachment, to secure various types of infill panels (plyboard, perspex, etc.) up to a thickness of 25/64". All clips are supplied with hexagonal head fixing bolts, M6x35mm long, and nut. For D and E dimensions the figures are given for the respective minimum and maximum dimensions allowed by the slotted hole. Ø indicates diameter of the safety attachment bolt hole. The primary clip has a slot measuring .31 x .59 inches

A fitting used in conjunction with Type 83 fitting for gate hinges. Ø indicates diameter of pivot hole.

A fitting normally used for attachment of chains.