iProperties of custom pipe fittings are not showing entered values when placed on a pipe run in Inventor

Products and versions covered

Inventor 2020, Inventor LT 2020, Inventor Nesting 2020, Inventor Products 2020, Inventor Professional 2020, & Inventor Tolerance Analysis 2020

By:

Support

Issue:

Users reported that iProperties (Project > Description) of custom pipe fittings were not updated and showing the wrong values when placed on a pipe run in Inventor. The same property was updated correctly if the fitting is not placed on a pipe segment.

Status:

This incident is being investigated for a possible cause and resolution.

Workaround:

Run File > Open > Open from Content Center to create an instance of a desired member (it has correct iProperties).

In Tube & Pipe environment, place the same member on a T&P segment.
Right-click the member and run Component > Replace to replace with the instance placed in step #1.

Products:

Inventor Products;

Versions:

2020;

Incident ID:

33847

(* {{l10n_strings.REQUIRED_FIELD}})

{{l10n_strings.CREATE_NEW_COLLECTION}}*

0 / 80

{{l10n_strings.COLLECTION_DESCRIPTION}} {{addToCollection.description.length}}/500

{{l10n_strings.CONTRIBUTION_ADDED_TO_COLLECTION}} {{addToCollection.collectionTitle}}.