Best Practices When Joining PVC Pipes

PVC is ridiculously easy to build with due to its sheer versatility and robustness. However, to ensure your entire PVC pipe system is completely secure you must pay particular attention to how everything fits together. This means more than just the structure of your system; it means how each section joins within the structure. Luckily, taking care of this is just as quick and easy!

There are two basic approaches to properly size and joining PVC pipe fittings. There is the solvent method, often referred to as the cementing method, or the fastening method. Let’s have a look to both of them:

The PVC Solvent Method

The first and most vital thought in picking a dissolvable is the similarity. On the off chance that the polymers and solvents utilized as a part of the holding procedure are not perfect, there won’t be adequate intermolecular development over the joint interface to make a stable bond.

Many people mistake this method as gluing two bits of plastic together. This is simply not the case. PVC cement doesn’t stick fittings together; it welds them! The solvent melts the surface of the PVC and infuses them together.

While solution holding is a straightforward and cheap strategy, making reliably great dissolvable welded joints requires a clear comprehension of a few key process steps.

Expert Tips When Using PVC Cement

• Double-check everything before fastening it all together and potentially wasting your time! Test your structure first and make sure you have the right measurements.

• Knock over the fittings or stuck pipe using the block of wood.

• Before attempting to glue any joint, it’s important to dry-fit your pipe and fittings to ensure proper sizing and alignment.

• Everything should be clean and free of dirt for the infusion process to take effect properly.

• Always allow at least 30 seconds for the cement to set.

• If you are trying to connect two pipes that have multiple connections required, it is highly recommended that you use a level.

· Look online for top reviews & buy PVC pipe fittings online!

• Avoid applying the cement anywhere other than where you need it.

The PVC Fastener Technique

You can also securely attach PVC pipes and fittings using screws, otherwise known as fasteners. To tell the truth, it is temporarily organic and connecting method. This is not a permanent connection and can be ‘unscrewed’ — but it is still structurally stable. By employing the fastener technique, you can reuse or reposition your pipes and fittings as and when required. This method is not as reliable as PVC cement.

Top Tips for Fastening PVC

• Use a mallet or small piece of wood to ensure your pipes are securely and comprehensively pushed into the fitting.

• Typically, inserts installed with heat yield the best combination of overall performance and lowest installed cost.

• Guarantee your Fasteners are Dimensionally Correct and Ensure the Assemblers are Using the Intended Fastener for the Application

• Make a pilot hole into the side of your fitting. This should be about halfway between where the pipe and fitting meet.

• Study tool options and pick tools that meet the need of the applications.

Which Method is Better?

To be fair, both methods work extremely well and prove to be ideal for industrial pipe fittings. PVC cement is highly recommended if you want the most secure and stable option. But there is no flexibility with this approach as once it is up, it’s up! The biggest advantage of the fastener method is that it is temporary. You can swap and change your structure easily by unfastening and starting again.

For expert advice on other PVC joining requirements, or for a broad range of PVC pipe system products, talk to the people at eeziflo-fittings (best PVC pipe supplier). They have everything you need in stock plus a team of pipe system specialists at your request. Now avoid loose elements at your end with eeziflo-fittings.com.